ARB 3415120 - Manual (Page 12)

Last Rev Date: 17 SEPTEMBER 2008 Page 12 of 20 Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION OF BULL BAR
FITTING WINCH
48. Fit large grommets to holes in top pan
49. Fit control box bracket to control box
studs as shown. Picture also shows
routing of leads through grommets in pan.
50. Using M8 fasteners fit control box
mounting bracket to pan
51. Prepare winch for fitting by undoing the
cap screws on the gearbox end.
52. Then rotate the end cap and gearbox in a
counter clockwise direction 144° ( four
hole pitches) while looking down at the
gearbox, as shown (for 12000lb winches
rotate clockwise 72°)
53. Tighten the cap screws ensuring the
gearbox handle operates freely.
54. For 8-9500lb only rotate the motor end
90° clockwise (elec. terminals will be up,
see step 59)
NOTE: 12000lb motor is in correct position
as supplied
NOTE: Be careful not to lift the gearbox more
than a few millimetres. Before doing up cap
screws, ensure that the flange faces engage
properly and gaskets are not damaged.
NEW
POSITION
ORIGINAL
POSITION