Removal of bumper cont – ARB 3415120 User Manual
Page 9
Last Rev Date: 17 SEPTEMBER 2008
Page 9 of 20
Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER Cont.
26. If fitting 12000lb winch, undo bolt
securing the brace attached to the
centre of grille cross member. See step
61 for picture of bracket.
27. Remove grille from bumper cover by
releasing plastic tabs as shown
28. Remove fog light brackets and set aside,
these will not be reused
29. Remove headlight washer circuit if fitted
and retain for reuse.
30. Remove fog light loom, if fitted, for reuse.
Note, the connections will need to be
removed to fit through the bull bar holes.
31. Place bumper face up on a bench or
similar so there is sufficient access for the
cutting operation
32. Using a jigsaw, carefully cut along the
edge of the masking tape.
33. Remove burrs from the cut edge of the
bumper, then set aside on the soft non
abrasive surface.
Cutting edge
Warning: Cutting
operations can result in
flying debris, safety glasses
should be worn. Work
safely; keep fingers clear of
cutting blade.
Cutting line