ARB 3415120 - Manual (Page 13)

Last Rev Date: 17 SEPTEMBER 2008 Page 13 of 20 Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION OF BULL BAR
55. Position the winch with the mount face
facing upward on an adjustable table or
similar and with the assistance of another
person lower the bulbar over the winch.
The winch handle should be in the LHS of
the bull bar for all winches except 12000lb
winch is on the opposite side. The cable
must spool off the bottom of the winch.
NOTE: The 12000lb winch will need to be at
the bottom of the adjustment slots.
Also follow the installation instructions in
the Warn winch handbook accompanying
the winch.
56. Fit the roller fair lead, pull only the end of
the cable through and adjust the position
of winch then bolt up securely. Use the 1
½” long bolts in the top and 1 ¾”in the
lower set through the RFL.
Hint: To increase access to mount bolts in front of
roller fairlead, remove circlips from bottom of each
vertical roller shaft, push shaft up so roller can be
dislodged sideways. Do up bolts in fairlead and
winch, then refit circlip.
57. With the aid of another person, turn the
bull bar over so that the back of the bar is
accessible.
58. Connect up the wires to the winch. Note
that the 12000lb winch requires
supplementary wire kit 3512050. Connect
the longer wires to control box
connections, marking them for correct
connection to motor terminals.
NOTE: Refer to the Warn winch handbook for
wiring instructions to winch and vehicle.
If fitting 12000LB winch only
59. Either relieve the forward section of the
vehicle bracing sheet metal member as
shown to clear winch tie rod, or bend it
back clear of where the winch will be
positioned.
Cut away the entire
forward section at
this line