ARB 3415120 - Manual (Page 15)

Last Rev Date: 17 SEPTEMBER 2008 Page 15 of 20 Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING MOUNT BRACKETS
Hint: Check that the M12 long bolts screw
freely into the clevis nut threads before
assembly.
Packers are supplied to compensate for
body to chassis variation if required
66. Insert clevis bolt with spring, large flat
washers and rectangular 8mm plate
washer through hole in mount bracket
rear flange as shown. Then loose fit
mount brackets to chassis.
67. Secure using existing OE M10 flange
nuts, but do not do up tight.
68. Replace tow hooks using existing bolts
but do not do up tight.
69. Insert clevis nut into rectangular hole in
outboard face of chassis, with the notch in
nut facing toward front of vehicle and
located at the outboard edge of chassis.
NOTE: If KDSS is fitted to vehicle the LHS nut
will have to be loaded to the chassis hole from
the inboard face (engine bay side).
70. The nut when positioned has a slot which
should snugly fit and locate the nut on the
outboard edge of the rectangular chassis
hole. The nut should protrude
approximately 7mm. Screw the clevis bolt
into the clevis nut, do not tighten yet.
71. Tap the outer flange of the mount
brackets until they are hard up against the
tow hook mount area. Nip up the lowest
outboard nut on each bracket. Brackets
should be about 935mm apart