ARB 3415120 - Manual (Page 2)

Last Rev Date: 17 SEPTEMBER 2008 Page 2 of 20 Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
GENERAL CARE AND MAINTENANCE
By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products
in the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent
value. To keep your bar in original condition it is important to care and maintain it following these
recommendations:
ƒ
Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed
surfaces. It is recommended that this is performed on a six monthly basis or following exposure to
salt, mud, sand or other contaminants.
ƒ As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual
inspection of the bar is carried out, making sure that all bolts and other components are torqued to
the correct specification. Also check that all wiring sheaths, connectors, and fittings are free of
damage. Replace any components as necessary. This service can be performed by your local
authorized ARB Stockist.
FITTING REQUIREMENTS
REQUIRED TOOLS FOR FITMENT OF PRODUCT:
Metric socket and spanner sets 8-25mm range External Circlip pliers
Screwdrivers, Philips and Flat blade Power Jigsaw with blade for plastic cutting
Short Body Power Drill 13mm (1/2”) capacity Dia 7.0mm (5/16”) and 10.5mm (25/64”) drill bits
Tin snips Marking pen
Half round file Soft Hammer
Metric hex key set Loctite© 262 or equiv.
Wide masking tape Stanley knife
Small Spirit Level Tape Measure & 2 x 300mm rulers
If fitting parking sensors: Dia 22.0 (7/8”) hole saw Paint black fast drying
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT :
Protective eyewear Hearing protection
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a
potentially hazardous situation it is suggested that protective safety gear be worn or a safe work
procedure be employed. If these notes and warnings are not heeded, injury may result.
FASTENER TORQUE SETTINGS:
SIZE Torque Nm Torque lbft
M6 9Nm 7lbft
M8 22Nm 16lbft
M10 44Nm 32lbft
M12 77Nm 57lbft
OPTIONAL LIGHT SETS TO SUIT THIS PRODUCT:
♦ FOG LAMP SET P# 6821201 ADD GXL ONLY P#MD02 LOOM KIT, P#180209 SWITCH AND
P#180215 SWITCH CAP FOR FOGS
♦ UP TO IPF 900 SERIES FOG OR DRIVING LIGHT SETS
♦ IPF 840 FYS
FOG LIGHTS CAN BE FITTED TO LOWER PAN AREA