ARB 3468010 User Manual
Page 16
Last Rev Date: 14 05 08
Page 16 of 21
Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
47. If you are going to fit a 8000lb or a
9000lb winch use the low profile zinc
plated control box bracket; but if you
are going to fit a 9000lb XP winch, use
the black powder coated angled
control box bracket.
48. Fit control box bracket to bar using
8mm hardware.
49. Fit rubber grommets into round
holes in top of bar, then fit control box
to control box bracket and pass cables
through rubber grommet.
50. Fit all 3 cables to their correct
terminals and tighten. Refer to Warn
installation instruction when wiring up
winch. Fit plastic boots over terminals.
Cable tie cables to bar as per photo to
clear of all moving parts.
51. Fit ground wire under winch tie rod.
( See Photo )
ARROW INDICATES
RUBBER GROMMETS.
GROUND WIRE