ARB 3468010 - Manual (Page 8)

Last Rev Date: 14 05 08 Page 8 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
14. The white marked out section in
photo, which runs along the tangent
line of the lower profile, has to be cut
out using a jig saw or a key hole saw.
15. This is to give clearance for the
winch.
16. The arrow shows a close up of the
drawn line to be cut.
17. Photo shows the two separate parts.