ARB 3468010 - Manual (Page 17)

Last Rev Date: 14 05 08 Page 17 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
52. Fit 10mm caged nuts into each side of
bar. ( 3 per side )
Assemble and install combination light
surrounds (p/n 3163015) as per
instructions no. 3786421 supplied with
surround kit. Note: Optional fog lamps can
be installed at this point as per fitting
instruction no. 3783315 supplied with fog
lamp kit no. 6821201.
Wire the combination lamp to the vehicles
indicator and clearance lamps.
Caution: Cable tie all cables together and
keep all cables clear of sharp edges and
moving parts.
54. Install the turn signal into the rear of
light insert using 2 self tapping screws
6 x 25mm pan head) supplied with the
light insert fitting kit.
NOTE :- The indicators should be
installed with the drain holes at the
bottom and are marked LH / RHS.
( Clearance lights outboard )
RHS SHOWN
ARROWS INDICATES POSITION OF
SCREWS