ARB 3468010 - Manual (Page 2)

Last Rev Date: 14 05 08 Page 2 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
GENERAL CARE AND MAINTENANCE
By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products
in the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent
value. To keep your bar in original condition it is important to care and maintain it following these
recommendations.
•
Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed
surfaces. It is recommended that this is performed on a six monthly basis or following exposure to
salt, mud, sand or other contaminants.
•
As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual
inspection of the bar is carried out, making sure that all bolts and other components are torqued to the
correct specification. Also check that all wiring sheaths, connectors, and fittings are free of damage.
Replace any components as necessary.
•
Please contact local Authorised ARB Stockist if you would like to have this service carried out on
your behalf.
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:
BASIC TOOL KIT JIG SAW OR KEY HOLE SAW
Small drill, 8mm,10mm and (13mm drill bit if fitting winch )
Protective eyewear Hearing protection
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a potentially
hazardous situation it is suggested that protective safety gear be worn or a safe work procedure be employed. If
these notes and warnings are not heeded, injury may result.
FASTENER TORQUE SETTINGS:
SIZE Torque Nm Torque lbft
M6 9Nm 4lbft
M8 22Nm 16lbft
M10 44Nm 32lbft
M12 77Nm 57lbft