ARB 3468010 - Manual (Page 20)

Last Rev Date: 14 05 08 Page 20 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
62. When bar is secured to mounting
bracket assembly, connect winch cables
to battery and cable tie cables together to
clear of all moving parts, sharp edges
and hot parts.
63. Lastly refit skid pan back to original
rear bolts ( finger tighten ) and align
front holes with holes in lower section of
bar.
64. Place packer in between skid pan and
lower section of bar and secure using
original 8mm bolts from vehicle.
65. When all bolts are fitted, tighten to
torque specifications.
66. If the bar is going to be fitted as a
non winch bar, a cover panel is
supplied in bolt kit with the 6mm
hardware, being two stainless steel pan
head bolts, 6mm flange nuts and
rubber extrusion which is fitted around
the outer edge of the panel.
VIEWED FROM INSIDE LHS OF VEHICLE