ARB 3436030 - Manual (Page 10)

13/12/05 Page 10 of 12 3783101
16. On the vehicle, remove the rubber air guide
on the lower cross member area and
discard.
IMPORTANT :- When fitting a winch, on
some models the top power steering cooler
line (steel) will interfere with the winch and
must be bent down to provide clearance as
shown .
Take care when bending the cooler line
tube that you don’t kink it.
Leave the power steering cooler in its
original position.
17. Using two people, three if winch fitted,
position the bar assembly on the vehicle
mounts.
Bolt the bar to the mounts using M12 bolts,
large flat washers and spring washers.
Align the bar to the profile of the guards
and tighten all bolts including the mount
brackets and 3 x bolts through each
original tow point mount.
18. When the bar position is finalised, it must
be pin bolted to the mount brackets. Using
a drill and 10mm drill bit, drill through the
upper and lower Ø10mm pinning holes
located in the mount brackets.
Fasten through holes using M10 bolts, flat
washers, spring washers and flange nuts.