ARB 3436030 - Manual (Page 5)

13/12/05 Page 5 of 12 3783101
4. With the bull bar mounting brackets now in
place (but not tightened) bolt the tension
strap to the chassis using the hole next to
the horizontal slot.
Using the M12 bolt, flat washers, spring
washer and nut, bolt up the tension strap
as shown.
Note: The tension strap will need to be
bent out slightly, to pass alongside the bull
bar mounting bracket.
As the bolt is tightened the bracket will
bend slightly to allow the strap to sit flat
against the chassis.
5. Bend the end of the strap inward, as
shown, to allow the strap to sit against the
bull bar mounting bracket.
Drill through the strap and bracket using a
12.5mm drill bit and bolt up using the same
hardware as described in the above step.
IMPORTANT: STRAP POSITION MUST BE
AS LOW AS PRACTICAL ON MOUNT
BRACKET AS SHOWN
6. If fitting winch.
Rotate clutch handle end
The clutch handle must be repositioned so
it is in a convenient location when mounted
to bar.
Place the winch on its end and remove all
gearbox bolts.
Gently raise the motor just enough to rotate
it. Viewing from the gearbox end, rotate the
gearbox 72deg clockwise.
Do not completely remove the motor and
avoid damaging the gasket.
Refit and tighten all bolts.
Note: Take care not to lift the assembly
more than a couple of millimeters while
rotating to the desired position to avoid un-
meshing the gears.
ORIGINAL
POSITION NEW POSITION
ROTATION
Drill Dia
12.5mm hole
for pinning