ARB 3436030 - Manual (Page 7)

13/12/05 Page 7 of 12 3783101
• For 16500lb winches, apply Sikaflex (or
similar product) to rear of control box trim
plate from fitting kit (note orientation critical
to suit final position with control box profile
in pan opening).
• Position trim plate on top of pan centrally
about control box opening and line up with
mount slots.
• Fasten in position with 2 x M10 cap screws
and flange nuts from fitting kit.
8. The roller fair lead may need to be drilled
prior to fitment.
Using a 13.0 mm drill bit drill two holes as
shown in diagram.
9. Viewed from front of vehicle the winch
clutch must be positioned on the LH side.
Cable spools from the bottom. Draw off
some cable so cable crimp can be pulled
through roller fairlead.
Bolt in position with the roller fair lead in
place and the tail of cable through rollers.
Note; To increase access to mount bolts in
front of roller fairlead, remove circlips from
bottom of each vertical roller shaft, push
shaft up so roller can be dislodged
sideways. Do up bolts in fairlead and
winch, then refit circlip.
Connect the winch control box cables to
the winch motor. Refer to the Warn
handbook for additional information.
Connect the long winch + & - cables to the
vehicle after the bar is installed. Refer to
the Warn winch manual for vehicle
wiring instructions.