ARB 3436030 - Manual (Page 9)

13/12/05 Page 9 of 12 3783101
If not fitting winch cont.
13. Wrap rubber extrusion around winch cover.
Place washers over the winch cover fixing
holes located on the top middle face of the
winch bumper.
Place the winch cover on top of the winch
bumper inline with the mount holes.
Bolt together using the M6 button head
stainless steel screws and M6 nuts.
14. Fitting indicators
Fit the indicator assemblies noting the RH
and LH designation. Use the nylon nut
plugs and the self tapping screws in the
bolt kit (discard screws, speed nuts and
rubber caps supplied with light assemblies)
Screws enter from the rear of the light body
flange. Position the light with the parker
(clear lens) towards the outside of bull bar.
NOTE: It may be easier, at this stage,
before bull bar is fitted, to temporarily
remove headlight surround or head light
and then connect the wiring looms for
indicators/clearance lamps to original
vehicle wiring through this opening
Ref step 19.
15. Fitting bull bar
Fit M8 cage nuts x 3 off to lower pan
section