ARB 3934020 - Manual (Page 13)

13/06/06 Page 13 of 13 3782863
30. 1. There are two dia 16 hole located on the top
face of the bar. If no CB arials are fitted the
holes can be covered with the plastic plugs
provided in the fitting kit.
2. Place the ARB logo on the front face of the
bar in the indentation.
31. If fitting fog lights, wire the fog lights as described in the fog light fitting instructions
The fog lights can be adjusted to desired angles by the adjustment bolts located at the back of the
light insert. When adjustment is finalised be sure to retighten the fog light bolts.
(If fitting with winch)
32. Connect the winch control box cables to the winch motor. Refer to the Warn handbook for additional
information. Connect the long winch + & - cables to the vehicle after the bar is installed.
Refer to the Warn winch manual for vehicle wiring instructions.
Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the
winch cables to the vehicle and winch bumper with the supplied cable ties.