ARB 3934020 - Manual (Page 4)

13/06/06 Page 4 of 13 3782863
ASSEMBLY SEQUENCE.
1. 1. Position the lower buffer on the winch
bumper and assemble using the M6 flange
nuts.
2. 1. Insert the side buffers through the holes and
fix using the M6 flange nuts.
NOTE
Sahara bumper buffer has no large top hole.
5. 1. Glue the light surrounds to the bar using a
silicone based rubber adhesive. Run the
bead along the cavity on the rear side of the
part. Position the surround to align the inside
edge with the buffer and concentric to the
light.
2. Wipe off any adhesive on the front face of
the bar. Allow adhesive to cure before
continuing.
3. If fitting optional fog lights, do so at this
stage.
4. If fitting Sahara Bumper go to step 7