ARB 3934020 - Manual (Page 8)

13/06/06 Page 8 of 13 3782863
15. Note: The washer bottle on the drivers side must
be removed to gain access to the top bolt.
1. Tighten all bolts.
16. 1. Fasten the wing braces to the vehicle using
M6 bolts flange nuts and washers.
17. (If fitting the winch.)
1. To place the winch clutch handle in a
convenient location the winch gearbox must
be rotated 2 hole spacings, 72 degrees, in an
anti-clockwise direction when viewed from
the gearbox end. Place the winch on its end
and remove all gearbox bolts. Gently raise
the gearbox just enough to rotate it. Do not
completely remove the gearbox and avoid
damaging the gasket. Refit all bolts and
tighten.
NOTE: Take care not to lift the assembly
more than a couple of millimetres while
rotating to the desired position to avoid
unmeshing the gears.