ARB 3934020 - Manual (Page 9)

13/06/06 Page 9 of 13 3782863
18. 1. To place the winch motor in the correct
location the winch motor must be rotated 90
degrees, in a clockwise direction when
viewed from the motor end. Place the winch
on its end and remove the 2 motor retaining
bolts. Gently raise the motor just enough to
rotate it. Do not completely remove the motor
and avoid damaging the gasket. Refit all bolts
and tighten.
NOTE: Take care not to lift the assembly
more than a couple of millimetres while
rotating to the desired position to avoid
unmeshing the gears.
19. 1. Bolt the winch and roller fair lead to the bar
using the bolts supplied. The longer bolts are
used for the two bottom holes through the
roller fair lead.
20. 1. Install the winch and roller fairlead using
bolts, nuts and spring washers supplied by
Warn, and the 4 x 3/8” flat washers supplied
in the bolt kit. Refer to Warn installation
instructions for correct procedure. Adjust
winch in slots until the winch is centralised in
the bull bar.
2. Assemble the control box bracket to the
control box using M6 flange nuts.
3. Mount the control box to the bar using M6 X
16 bolts and M6 flange nuts.
NOTE: The gearbox is on the passenger side
for the 8,000lb and 9,000lb. The cable spools
from the bottom for the two winches
mentioned.