ARB 3932020 - Manual (Page 4)

13/6/08 Page 4 of 11 3786950
6. When drilling the vertical pinning bolt THE
DRILL MUST BE STRAIGHT IN BOTH
DIRECTIONS. Failure to do so will result in
damage to the radiator mounting system. Drill
out both holes and assemble using the long
M10 bolts and hardware supplied. From the
out board side of the chassis insert the chassis
packers between the under side of the chassis
and the impact absorber with the finger tab
facing downward. Repeat this on the LHS.
This picture shows how to fit chassis packer in
between chassis bracket and chassis rail.
Picture is of RHS of vehicle
7. The plastic air shield needs to be trimmed
before being replaced, cut the holes (located
on the edge tabs) into an open ended slot.
Place the shield back into its original position
and screw across the back edge in 3 locations.
The edge tabs are now pushed in on top of the
spacer, the tabs are retained when the vertical
bolts are done up between the chassis and the
chassis spacer.
Re – confirm the measurement between
the impact absorbers and tighten all of
the vertical bolts.
8. Remove the horizontal bolts only, as previously
described in step 3. Re – assemble but this time
the tubular cross brace and the original
recovery point are attached.
Note: the recovery bracket is located to the left
hand chassis rail.