ARB 3932020 - Manual (Page 9)

13/6/08 Page 9 of 11 3786950
22. Fit control box to bracket and connect all
power cables to winch motor as per warn
instructions.
23. Connect ground wire to winch tension bar.
24. Cable tie all cables together and keep clear of
sharp edges and all moving parts.
When bar is fitted to vehicle, fit both
power cables to battery and cable tie to
vehicle keeping clear of all moving parts.
25. With assistance lift the bar into position
and slide it over the two impact absorbers.
Once in position bolt up the bar in the 8
places using the M10 bolts & hardware
supplied, finger tight only at this stage.
Adjust the bar on the vehicle until a uniform
gap is achieved to the grille & headlamp
and guards. Once happy with the position of
the bar tighten all of the bolts.
The bar is then drilled and pined in its
final position using the M10 hardware
supplied as shown in the attached photo.
26.Re-connect the fog lamp harness and the
turn signal harness on both sides of the
vehicle, cable tie the wiring where
appropriate.
Ensure the turn signal & fog lamps are
working correctly.
Reconnect the head lamp washer tubes on
both sides.