ARB 3932020 - Manual (Page 5)

13/6/08 Page 5 of 11 3786950
9. Placing the original bumper bar face down
on a blanket remove all of the screws that hold
the painted outer section to the main bumper.
Using pliers remove the clip that holds the
washer nozzle in the bumper and take out the
nozzle (both sides). These are re-fitted into the
bar once the fog lamp and turn signal are
installed.
Using a small flat bladed screw driver dis-
engage the locking tabs on both sides and
remove the cover, this will enable the fog lamp
to be un-screwed in three places and removed.
10. Fit the “u” nuts to the fog lamp bracket as
shown, the nylon washer fits between the
bracket and the lamp mounting foot
(located on the adjustment side) fit the fog
lamp with the screws provided.
Note:- The Left hand fog lamp is shown.
Insert the nylon plugs into the square holes
in the turn signal aperture, located on the
inside face of the bar. From the rear,
screw the turn signal assembly to the
bracket on the bar.
Re-fit the washer nozzle both sides once the
fog lamp & turn signal are fitted. The
washer retaining clip may need to be
flattened slightly to fit.
NYLON PLUG