ARB 5620010 - Manual (Page 10)

17. Fitting the cover trim and aluminium top
With the door open, fit the 4 M6 cage nuts to
the centre holes of the rear bar, then place
the cover trim in position and fit using M6
Button head cap screws. Then place the
aluminium on top and fix using M6 Button
head cap screws.
Then place the aluminium on top and fix using
M6 Button head cap screws.
Once fitted to the vehicle, peel the back off the
reflectors and stick them to the outer wings of
the bar as shown.
18. If re-fitting parking sensors, place the wiring
loom over the chassis rails and plug into the
socket at the bottom of each quarter panel.
There is a black clip which can be pressed
into a slot in the chassis to stop the wiring
moving.
19. Finally refit the exhaust mount by hooking the
exhaust into the hole in the rubber, and then
pushing the rubber mount towards the front of
the vehicle without pushing the rubber off the
black pins on the chassis.
Fitting trim panel
Fitting Aluminum plate
Push top and bottom
equally
Last Rev Date: 13/3/07 Page 10 of 10 Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd