ARB 5620010 - Manual (Page 8)

9. Once the bumper has been cut, refit each
corner to the vehicle by clipping it the top and
side and refitting the screw to the underside.
Refit the scrivet on the passenger side.
10. Before fitting the rear bar, the exhaust mount
must be released by pulling the rubber mount
towards the rear of the vehicle and allowing
the exhaust to drop slightly. This allows
access to the bolt holes.
11. The tab found below the door opening in the
centre of the car must be gently bent down to
vertical with a hammer.
12. Before the bar is fitted, the M6 cage nuts
must be fitted to the outside 6 holes only.
Fitting the cage nuts to the centre holes will
be done once the bar is fitted.
Pull rubber towards
rear of vehicle
Push exhaust slightly towards
front of vehicle until it is
released from rubber mount as
shown
3 Cage nuts each side
Last Rev Date: 13/3/07 Page 8 of 10 Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd