ARB 5620010 User Manual
Page 5
4.
Once the clips are undone, the bar can be
removed. With the bar removed the support
brackets, tow hook and foam can also be
removed.
5.
With the bumper removed from the car it can
now be trimmed. First remove the silver end
caps by releasing all (5) retaining clips. Then
release the clips for the parking sensor wiring.
If the parking sensors are to be refitted,
remove them from the bar by sliding the large
plastic clip sideways and remove from bar.
Lift off foam
Remove bracket, left
and right
Remove brackets from
underside of body and
from chassis. Also
remove tow hook
Last Rev Date: 13/3/07
Page 5 of 10
Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd