ARB 5620010 - Manual (Page 4)

FITTING PROCEDURE
1. To fit the Rear Bar, the plastic bumper must
be cut. This is done at a later stage.
2. Removing the plastic bumper from the
vehicle.
There are 4 bolts along the top, 2 underneath
the centre of the bar, 1 screw on the
underside of each end, which must be
retained, and a scrivet located on the
passenger side of the vehicle in the door
jamb which should also be retained.
Also undo the connectors for the parking
sensors located in the lower corner of each
end of the bar.
3. Once all fasteners have been removed, the
bar can be pulled off the clips on each end by
pressing down on the top edge whilst pulling
the side out and back. Take care during this
operation as the corners of the bar must be
reused.
2 underside bolts
Scrivet
End screw to retain
4 top bolts
Last Rev Date: 13/3/07 Page 4 of 10 Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd