ARB 5620010 - Manual (Page 6)

6. Marking the cut lines
Corner section cut line
Images are of the left hand (drivers) side
First measure down 25mm from the rebate
and scribe a line (1) on the curved inner
face.
Then run a line (2) down the corner of the
vertical face and the centre section of the
bar, followed by a line (3) along the bottom
as shown.
Place a ruler between the end points of the
two lines and draw a line (4) as shown.
For the final line (5) join the top of line 2 and
the start of line 1 as shown.
This line can be cut to remove the corner
from the centre section
Square section cut line
Start by measuring 40mm from the edge and
draw a line (A) down using a square.
Then but the ruler into the plastic whilst
resting the top surface of the box section and
mark on each side of the ruler at 20mm
Repeat this process this time placing the
ruler between the two double ribs and
marking each side of the ruler at 35mm out.
Join the first 2 marks with a line (B), and the
second 2 marks with a line (C).
Measure 25mm down
and scribe line 1 here
Line 2
Line 3
Line 4 Line 5
Line C Line B
Line A
Last Rev Date: 13/3/07 Page 6 of 10 Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd