Fitting procedure – ARB 5620010 User Manual
Page 9
FITTING PROCEDURE
Passenger side Drivers side
(with trimmed clip)
13. If parking sensors are to be fitted, insert them
in the holes with the wiring pointing towards
the outside of the bar as shown.
NOTE: the passenger side sensor clip will
require trimming as shown below.
14. The rear bar can now be fitted.
Carefully slide the rear bar over the chassis,
taking care not to damage the plastic bumper.
This may require 2 people.
15. With the bar sitting on the vehicle, place the
recovery hook on with the large offset to the
bottom, and attach to the front face using
M12 x 50 x 1.25 bolts, 12mm flat washers
and 12mm spring washers.
Do not fully tighten.
16. Take the chassis spacer and place between
the chassis mount and the chassis of the
vehicle. Attach using M12 x 50 x 1.25 bolts,
12mm flat washers and 12mm spring
washers.
Check alignment of bar to vehicle, and then
tighten all bolts to specified torque
One person each side to lift bar into place
Large distance between bolts and
end of plate to the bottom
Last Rev Date: 13/3/07
Page 9 of 10
Fitting instructions# 3786375
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd