Fast & Fluid SK550 - Manual (Page 9)

p9
Fast & Fluid Management - SK550
Installation
Step 1 - Unpack the machine and unlock the frame lock
> >
Remove box and plastic foil. Note
the frame lock bolts on either side
of the machine. Remove both bolts with a size 17
fork wrench. By removing the bolts, the frame
lock’s wooden block is released.
Be careful not to damage the body and surfaces of your SK550 with any
tools while unpacking it. Take care not to accidentally close the door
before finishing installation, as it can then only be unlocked from User
Menu U2.
Step 2 - Remove the frame lock
> >
Pull out cord to remove frame
lock’s loose parts. Ensure all loose parts have
been removed – two bolts
and two wooden blocks. Connect the SK450 to the
power mains before closing
the door.
Attention! Failure to remove the frame lock correctly can result in
severe damage to your SK550 when in operation. Please take care!