SkyTrak 6036 Service Manual - Manual (Page 328)

Section 10. Electrical System
10-66 Model 6036/6036T S/N 9B0500 thru 14833
Trouble Probable Cause Remedy Reference
Gauges and Indicator Lights—WARNING LIGHTS
Bulbs in warning
lights gauge fail to
light when test
button is pressed. Replace bulbs.
Test switches for continuity
under the appropriate
conditions and replace as
required.
Replace switches.
See para. 10.8.4
See para. 10.8.4
thru 10.8.8
See para. 10.8.5
thru 10.8.8
Gauges and Indicator Lights—ENGINE LOW OIL PRESSURE SWITCH
Oil Pressure
Indicator does not
go out when the
engine is running. If the oil level and oil pressure
are good and voltage is zero,
check for shorts to ground. If there are no shorts to
ground, install a new oil
pressure switch. See para. 10.8.5
1. Bulbs are burned out.
2. No voltage at warning
lights gauge; loose or
broken wiring or circuit
breaker doesn’t reset.
3. Defective sender switches.
Bulbs in warning
lights gauge light
continuously
when ignition key
switch is in RUN
position. 1. Defective test switch.
2. Short circuit in wiring.
3. Defective sender switches.
Check test switch for
continuity and replace switch
if closed in the released
position.
Determine and repair the
cause of the short circuit.
Test switches for continuity
under the appropriate
conditions and replace as
required.
See para. 10.8.4
See para. 10.8.5
thru 10.8.8
With a good oil
pressure indicator
bulb and the
ignition key in
RUN, oil pressure
indicator does not
light before
engine is started. 1. Oil pressure switch should
be closed.
2. There is battery voltage
with the ignition key in
RUN and the engine not
running.
If open, replace oil pressure
switch.
Install a new oil pressure
switch.
See para. 10.8.5
See para. 10.8.5