SkyTrak 6036 Service Manual - Manual (Page 37)

Section 4 Operator's Cab
Model 6036/6036T S/N 9B0500 thru 14833 4-1
CONTENTS
Par. Title Page
4.1 SEAT .................................................. 4-1
4.2 MECHANICAL HAND CONTROLS .... 4-1
4.2.1 Steering Wheel and Steering Unit ............. 4-2
4.2.2 Travel Select and Range Select
Levers ........................................................ 4-2
4.2.3 Boom Control and Grille and Frame
Tilt Joysticks .............................................. 4-4
4.3 ELECTRONIC JOYSTICK .................. 4-5
4.3.1 Troubleshooting (without TLC) .................. 4-5
4.3.2 Visual Inspection ....................................... 4-5
4.3.3 Electronic Joystick Calibration
(without TLC) ............................................. 4-6
4.3.4 Electronic Joystick Resistance Check
(without TLC) ............................................. 4-8
4.3.5 Electronic Joystick Resistance Adjustment
(without TLC) ............................................. 4-8
4.3.6 Electronic Joystick Removal and
Replacement (without TLC) ....................... 4-9
4.4 MECHANICAL FOOT CONTROLS .. 4-10
4.4.1 Service Brake Pedal ................................ 4-10
4.4.2 Throttle Pedal and Cable ......................... 4-11
4.5 REAR VIEW MIRRORS ................... 4-13
4.5.1 Mirror Head Adjustment ........................... 4-13
4.5.2 Mirror Cleaning and Inspection ................ 4-13
4.1 SEAT
The seat, Fig. 4.1, is mounted on an adjustable
suspension unit. The seat assembly consists of a
seat cushion and two slides. One of the slides has
a forward/backward adjustment lever. A seat belt
is attached to the seat.
a. Adjustment
You can adjust the seat for your weight and height
and position it horizontally and vertically.
Position the seat for your height by simply pulling
up on the seat until the desired level (low, middle,
or high) is attained. To return the seat to the low
level, raise the seat past the high level and allow it
to return to the low level.
Adjust the seat to your weight by turning a suspen-
sion adjust knob on the front of the suspension
unit until you see your weight in kilograms
(2.2 pounds per kilogram) on an indicator next to
the knob.
Adjust the horizontal or forward/backward position
of the seat by using the forward/backward lever on
the slide to the left of the seat.
b. Seat Removal
The seat and seat slides may be removed from
the suspension unit and mounting plate by remov-
ing four locknuts and flat washers that attach the
seat slides to the suspension unit.
SEAT
CUSHION
SLIDES
SUSPENSION
ADJUST KNOB
SEAT
BELT
FORWARD/
BACKWARD
LEVER
Fig. 4.1 Seat
OA0071
Fig. 4.2 Mechanical Hand Controls
N
R
F
DANG
ER
4.2 MECHANICAL HAND
CONTROLS
Mechanical hand controls in the operators cab are
shown in Fig. 4.2.
TRAVEL
SELECT
LEVER
RANGE
SELECT
LEVER
STEERING WHEEL
AND STEERING
UNIT
BOOM
CONTROL
LEVER
GRILLE AND FRAME
TILT CONTROL LEVER
LOWER PANEL
OA0021A
SUSPENSION
UNIT
SECTION 4
OPERATOR'S CAB