SkyTrak 6036 Service Manual - Manual (Page 34)

Section 3 Boom
3-16 Model 6036/6036T S/N 9B0500 thru 14833
Fig. 3.21 Quick Attach Assembly
2. Install quick attach assembly (10) on goose-
neck (7) with quick attach pin (8). Lock the pin
in place with capscrew and locknut (6).
3. Lubricate the pin through grease fittings using
a good grade of multi-purpose lithium based
grease.
4. Install grille tilt cylinder rod (14) on the quick
attach assembly with cylinder rod end pin (12).
Lock the pin in place with capscrew and
locknut (13).
5. Lubricate the pin through grease fitting using a
good grade of multi-purpose lithium based
grease.
6. Install the attachment on the quick attach
assembly.
4, STRETCH
OVER LATCH
1
6
14
12
2
4, STRAIGHT
END
8
7
5
3
11
9
13
10
MA0131
3.3 QUICK ATTACH
ASSEMBLY
The quick attach assembly, Fig. 3.21, provides a
structure on which an attachment may be installed
or removed from the forklift.
a. Removal
1. Fully lower boom and ground the attachment.
2. Remove the attachment from the quick attach.
3. Remove capscrew and locknut (13, Fig. 3.21)
locking grille tilt cylinder rod end pin (12) in the
quick attach.
4. Tap the grille tilt cylinder rod end pin from the
quick attach.
5 Remove capscrew and locknut (6) locking
quick attach pin (8) in the quick attach.
6. Tap the quick attach pin from the quick attach.
7. Remove quick attach assembly (10) from
gooseneck (7).
8. Remove the latch assembly capscrew (1), flat
washer (2), locknut (5), spring (4), spacer, and
latch (3) if any replacement is necessary.
b. Installation
1. If the latch assembly was removed, install it as
follows:
(a) Assemble flat washer (2, Fig. 3.21), latch
(3), spacer, and spring (4) on the cap-
screw.
(b) Install capscrew (1) on the quick attach
making sure the straight end of the spring
rides on the top edge of the weldment
plate.
(c) Install, snug and then back off locknut (5)
as required to permit free rotation of latch
(3).
(d) Stretch the spring hook over the latch.
8. Pin, quick attach
9. Fitting, grease
(both ends)
10. Quick Attach Assembly
11. Fitting, grease
12. Pin, grille cylinder
13. Capscrew and Locknut
14. Rod, grille tilt cylinder
1. Capscrew
2. Washer, Flat
3. Latch
4. Spring
5. Lock nut
6. Capscrew and
Lock Nut
7. Gooseneck