Lull 944E-42 Service Manual - Manual (Page 155)

5.9 Model 644E-42/944E-42 Rev. 6/04
Axles, Drive Shafts, Wheels, Tires and Brakes
Note: If new frame sway (front) or stabilizer (rear)
cylinder bearings (11) have been installed in the axle,
the fracture in the bearing race must be positioned at the
9 o’clock (20) or 3 o’clock (21) positions.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
7. Move the cylinder (12) into position on the axle
cylinder anchor (13). Insert a cylinder mount pin (14)
through the cylinder and cylinder anchor. Secure the
cylinder mount pin (14) with one capscrew (15) and
a new elastic locknut (16). Torque to 12-22 lb-ft
(17-31 Nm).
8. Apply multi-purpose grease through the lube fitting
(17) to lubricate the self-align bearing (11) and the
cylinder mount pin (14).
9. Install the drive shaft assemblies (18-Front or
19-Rear). (Refer to Section 5.4.4, “Drive Shaft
Installation.”)
MU0610
6
7
8
9
10
11
12
13
14
15
16
15
9
10
10
16
17
10
8
12
17
11
18
19
14
1
2
3
4
5
6
7
8
9
10
11
12
MT0820
20
21