Lukas LH 2/ 1,8-70 DIN - Manual (Page 17)

17
10.5 Repair
ATTENTION!
Because LUKAS devices are designed for the highest performance, only
components may be replaced that are listed in the spare parts lists of the
corresponding device and whose replacement is described here.
Additional components of the equipment may only be replaced if:
- You have participated in a corresponding LUKAS service training course.
- You have the express permission of LUKAS customer service (by request,
check on the grant of permission. A check is necessary in each
individual case).
10.5.1 Base plate replacement
The base plate must be replaced if external damage is present that represents a danger for
user and device upon further use. In particular, the base plate must be replaced if the stability
of the hand pump can no longer be ensured.
Procedure:
1. Remove screws A and B.
2. Remove base plate C and replace it with a new one.
3. Reinsert screws A and B and tighten.
A
C
B
10.5.2 Removing tank for cleaning, replacing the tank or the seals
The tank should be cleaned at least once per year in order to remove the accumulated dirt.
The tank must be replaced if there is any external damage that impairs the safety of
the device.
The tank seals must be replaced if there are any leaks at the junction points of the tank.
Procedure:
1. Remove base plate as described in the chapter "Replacing
base plate".
2. Empty tank by removing the screw plug (item D) and emptying
the tank.
D
ATTENTION!
Properly dispose of the removed hydraulic fluid and all
damaged components!