sPOD JK Instructions 2012-2015 User Manual

sPOD For the car

background image


POD Installation Instructions

2012 - 2015 Jeep JK Wrangler



Remove these


Keep this hole clear!

It is used for the plastic

windshield header alignment stud

On some plastic pieces, you may have to

trim a small amount off in this area

on both sides to clear bracket.

Attach switch bezel assembly to the bracket using
the 10-32 Phillips head screws supplied. Do not
tighten until bezel fits snugly against plastic
windshield cover.

After installation

You must start engine to activate system!!!

Allow approximately 1 hour for installation

Tools required

Phillips head screw driver.

8mm, 10mm, 12mm sockets

T-20 TORX bit & T-25 TORX bit


Remove the Freedom/Soft top for easier access during installation.

Remove existing plastic windshield header cover by swinging the visors out of the way and pulling the

plastic windshield header straight out until all 4 clips pop out of windshield frame.

Remove visor using the T-20 TORX bit.

Use a T-25 TORX to remove existing footmans loop from windshield frame.

Align the bezel bracket over the footman loop and reattach the assembly back on to the windshield frame

with the bezel bracket attached on the outside of the footman loop as shown below.

Re-install the plastic header back on and snap into place. Tuck the harness behind the plastic windshield.