IKA KS 130 control - Manual (Page 19)

19 032007
Page
Warranty 2
Safety instructions 19
Proper use 20
Unpacking 21
Useful facts 21
Commissioning 21
Switching on 22
Display 22
Operating modes 23
Setting the agitation time 26
Setting the speed 27
Attachments 28
Supported weight (load) 28
Error codes 29
Interface and outputs 30
Communication between laboratory instrument and PC 32
Motor protection / safety device 33
Maintenance and cleaning 33
Accessories 34
Technical data 34
List of spare parts / Spare parts diagram KS130 basic 52/53
List of spare parts / Spare parts diagram KS130 control 54/55
In order to be able to use the appliance properly and safely, every
user must first read the operating instructions and observe the
safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed
by everyone.
Only staff who have been trained accordingly, know the appliance
and are authorised to carry out work in this field should use this
appliance.
The machine may only be opened by trained specialists - even
during repairs. The machine is to be unplugged from the mains
before opening. Live parts inside the machine may still be live for
some time after unplugging from the mains.
NOTE ! Covering or parts that are capable of being
removed from the unit without accessory equipment have
to be reattached to the unit for safe operation in order to
prevent, for example, the ingress of fluids, foreign matter, etc. .
When working with the shaking unit, the user must select and
wear his personal protective equipment according to the mixing
hazard category.
Defective or inadequate protective equipment
can expose the user to the risk
of spurting liquids, projectile
parts or being pulled in at the
shaking table or support.
Never touch moving parts (risk
of crushing, impact and cut-
ting, see fig. 1: Danger zones).
Ensure that parts of the body,
hair or items of clothing cannot
be trapped by the motion
parts.
Please follow the relevant
safety instructions and guideli-
nes, and occupational health
and safety regulations for use
in the laboratory.
Beware of the high dead
weight of the appliance when
transporting. Ensure that your
fingers do not get crushed when setting down the appliance.
Always install the appliance on a flat, stable non-slip base.
Before use, please ensure that the knob for setting the shaking
rate is at the left stop as the appliance starts up at the last shaking
rate which was set. Pay attention to the vessels on the shaking
table when setting the shaking rate. This will prevent any of the
Contents
Safety instructions
fig. 1 danger zones