IKA KS 130 control - Manual (Page 25)

25 032007
adopted for speed and time and cannot be modified. When you
turn on the device with the power switch, a C is shown on the
display for operating mode C along with * in the display.
After the power has been turned off, the device will
automatically start up in operating mode C by itself.
After you have selected operating the mode and turned on the
device, the folling process will be shown on the display.
a.) All display elements in the digital displays are activated for
about 2 seconds.
b.) The device type (left display) and operating mode (right dis-
play) are displayed for about 2 seconds.
c.) IThe set time target value (for example 3:58) is displayed with
the indication h min and SV .The set (or stored) upper speed
limit from operating mode A is displayed with SAFE and OK for
about 2 seconds. The display upper speed limit cannot be modi-
fied by pressing and turning the turn button.
d.) The new speed target value that has been set or just stored
in the left display (for example 130) from operating mode A or B
is then shown with the unit 1/min and flashing SV .
e.) by pressing the left or right turn button, you can place the agi-
tator in operation. The speed and time values are then shown in
large format on the display. In addition, the text PV is shown
on the display instead of SV .
The actual value of the time setting must be understood from
this point onward as the time remaining for the agitation pro-
cess. If the time remaining has reached zero, the agitator stops
its motion.
Switching the operation mode:
The following steps are required to switch the operating mode:
a.) Turn off the device with the power switch.
b.) Hold down both turn buttons and turn on the device with
the power switch. After about 1 second, you can let go of
the turn buttons.
c.) It is not possible to switch between operating modes A, B
and C in any order.
Instead, you can only switch by repeating the steps above
A - step a.) + b.) >B - step a.) + b.) >C - step a.) + b.)>
A - step a.) + b.) >
Setting the audio time expiration signal
The following steps are required to activate the audio time expi-
ration signal:
I30
KS C
✱
230
SAFE
min n
i
358 :
SV
OK
✱
I30
I
min
/
SV
min n
i
358 :
SV ✱
I30
I30
I
min
/
PV PV
min n
i
356 .
358
:
✱