JLG 4017PS Operator Manual - Manual (Page 100)

Section 5 - Attachments and Hitches
5-8 31200753
Sample Capacity Chart (AUS)
Note: This is a sample capacity chart only! DO NOT use this chart, use the one
located in your operator cab.
XXX xx MAX
-
XXX xx
XXX xx
XXXX
XXXX XXXX
XX
XX
XX
XX
XX
XX
XX
o 10
o 20
o 30
o 40
o 50
o 60
o 75
o 0 XX
XX
XX
XX
XX
XX
XX
XX
XX
XX XX XX XX XX XX XX XX XX XX
XXX mm
XXXX
XXXX
XXXX
XXXX
XXXX
XXXX
XXXX
XXXX
A
B
C
D
TRAVELING (PICK & CARRY)
REQUIRES FIRM SURFACE WITH
LOAD ON FORKS.
MAX TRAVEL WITH RATED LOAD XXKM/H.
BOOM FULLY RETRACTED.
LIFTING (STATIONARY)
REQUIRES FIRM SURFACE WITH LOAD ON FORKS.
SPECIFICATIONS FOR SAFE USE
1. TYRE SIZES:
- XX XX (XXXXX) XX PSI / XX BAR
- XX XX (XXXXX) XX PSI / XX BAR
- XX XX (XXXXX) XX PSI / XX BAR
- XX XX (XXXXX) XX PSI / XX BAR
2. IN SERVICE WIND SPEED:
- XXM/S (XXKM/H)
3. GROUND CONDITIONS:
- FIRM SURFACES FOR BOTH LIFTING
AND TRAVELING.
- SLOPE AND LOAD LISTED ABOVE FOR
BOTH CONFIGURATIONS.
4. STANDARD USED: XX XXXXXXXX XXXXXXXXXXX
XXXMM MAX
X° MAX
XXXMM MAX X° MAX
X° MAX
XXXMM MAX
X° MAX X° MAX
X° MAX
OAM2730
This Capacity Chart may
be used with this model
ONLY. The telehandler
model is indicated on
the boom or chassis.
Model XXXX is used
for demonstration
purposes only.
Boom Extension
Indicator (arc) Boom Angle
Load zones indicate the
maximum weight that
may be safely lifted.
Load center must
be equal to or less
than value shown.
Attachment type,
weight and
dimensions must
be equal to or less
than the data
shown.
Specifications
For Safe Use
Lifting
Information
Traveling
Information
Traveling
Information