JLG 4017PS Operator Manual - Manual (Page 51)

Section 3 - Controls and Indicators
3-7 31200753
8. Anti Theft Code Entry: If active, the four digit code must be entered after system
start. See “Anti Theft” on page 3-28 for details.
9. Menus: Menus display fault codes and other machine information while allowing
modification of some operating parameters. Depress and hold the C and OK
buttons on the keypad to access menus.
a. Help - Displays active fault code. Depress OK button again and use keypad
arrows to cycle through the last 25 fault codes. Active faults are denoted
with an asterisk.
b. Operator Tools - Speed, Temperature and Oil Pressure units and Steering
Alignment Mode can be modified by the operator. Customer or Service level
access code required to modify additional items.
• Machine Speed - Select units (km/h or m/h) to be displayed.
• Engine Temperature - Select units (Celsius or fahrenheit) to be
displayed.
• Steering Alignment Mode - Select mode (manual or all wheel assisted)
to be used when changing steering modes, see page 3-30.
c. Personalities - View performance parameters. Customer or Service level
access code required to modify parameters.
d. Access Level - Code entry determines access level.
• Operator (Level 3) - No code required.
• Customer (Level 2) - See Service Manual for information.
• Service (Level 1) - Manufacturer service representative only.
e. Diagnostics - View diagnostic information.
f. System Test - Performs test of all system inputs and outputs.
g. Machine Setup - View machine configurations. Service level access code
required to modify configurations.
h. Calibrations - Customer or Service level access code required.
OAH2000
MENU:
HELP: PRESS ENTER
9