JLG 4017PS Operator Manual - Manual (Page 39)

Section 2 - Pre-Operation and Inspection
2-13 31200753
5. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
6. Mirror - Clean and undamaged.
7. Cab and Electrical -
• General appearance; no visible damage.
• Frame level indicator(s) and window glass undamaged and clean.
• Gauges, switches, joystick, foot controls and horn operational.
• Check seat belt for damage, replace belt if frayed or cut webbing, damaged
buckles or loose mounting hardware.
8. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
9. Rear Axle - Steer cylinders undamaged, not leaking; pivot pins secure;
hydraulic hoses undamaged, not leaking.
10. LSI Sensor - See inspection note.
11. Main Control Valve - See inspection note.
12. Mirror - Clean and undamaged.
13. Wheel Chock (if equipped) - See inspection note.
14. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
15. Engine Compartment -
• Drive belts, check condition and replace as required.
• Engine mounts - See inspection note.
• Battery cables tight, no visible damage or corrosion.
• Engine cover properly secured.
16. Boom Sensor - See inspection note.
17. Mirrors - Clean and undamaged.
18. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
19. Frame Level Cylinder - Pins secure; hydraulic hoses undamaged, not leaking.
20. Right Outrigger - Pins secure; hydraulic hoses and cylinder undamaged, not
leaking.
21. Platform Recognition Sensor (AUS - if equipped for platform): See inspection
note.
22. Attachment - Properly installed, see “Attachment Installation” on page 5-11.