JLG 4017PS Operator Manual - Manual (Page 124)

Section 5 - Attachments and Hitches
5-32 31200753
Fork Extension
Use Carriage Attachment Capacity Chart
To determine maximum capacity, refer to “Telehandler/
Attachment/Fork Capacity” on page 5-4.
Note: The maximum capacity of the carriage when equipped with fork extensions
may be reduced to the capacity indicated on the fork extensions. If the load exceeds
the capacity of the fork extension contact JLG to obtain forks and/or fork extensions
of the proper load rating and length.
The joystick (1) controls movement of the boom.
The attachment tilt roller switch (2) controls carriage tilt.
• Push roller switch down to tilt up.
• Push roller switch up to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
page 5-11.
• Ensure length and cross section of the parent fork arm is equal to or exceeds the
parent fork arm blade length stamped into the fork extension.
• Secure the fork extensions to the forks by sliding the fork extension onto the
parent fork and install the retaining pin behind the vertical shank of the fork.
OZ0750
OB0270
1
2