JLG 4017PS Operator Manual - Manual (Page 168)

Section 7 - Lubrication and Maintenance
7-16 31200753
Tires
A. Tire Air Pressure Check
1. Perform “Shut-Down Procedure” on page 4-3.
2. Remove valve stem cap.
3. Check tire pressure.
4. Add air if required. See page 9-3 for tire pressures.
5. Replace valve stem cap.
B. Tire Damage
For pneumatic tires, when any cut, rip or tear is discovered that exposes sidewall or
tread area cords in the tire, measures be taken to remove the product from service
immediately. Arrangements must be made for replacement of the tire or tire
assembly.
For polyurethane foam filled tires, when any of the following are discovered,
measures must be taken to remove the product from service immediately.
Arrangements must be made for replacement of the tire or tire assembly.
• a smooth even cut through the cord piles which exceeds 7,5 cm (3 in) in total
length.
• any tears or rips (ragged edges) in the cord plies which exceeds 2,5 cm (1 in) in
any direction
• any punctures which exceed 2,5 cm (1 in) in diameter.
If a tire is damaged but within the above noted criteria, the tire must be inspected
daily to ensure the damage has not propagated beyond the allowable criteria.
C. Tire and Wheel Replacement
It is recommended that a replacement tire to be the same size, ply and brand as
originally installed. Refer to the appropriate parts manual for ordering information. If
not using an approved replacement tire, the replacement tires must have the
following characteristics:
• Equal or greater ply/load rating and size of original.
• Tire tread contact width equal or greater than original.
• Wheel diameter, width and offset dimensions equal to the original.
• Approved for the application by the tire manufacturer (including inflation pressure
and maximum tire load).
10
OW0970
OW1040