JLG DVSP Series Operator Manual - Manual (Page 33)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-13
2. Drive Mode Indicator
When the Drive/Lift Mode Selector Switch is set to
DRIVE MODE the round LED indicator on that portion
of the display panel will light up indicating the DRIVE
Mode active.
3. Lift Mode Indicator
When the Drive/Lift Mode Selector Switch is set to LIFT
MODE the round LED indicator on that portion of the
display panel will light up indicating the LIFT Mode
active.
4. Drive Speed Setting Indicator
The five (5) GREEN LEDs on the top of this indicator
display the drive speed setting with the TURTLE (on
the left) representing the MINIMUM speed setting and
the RABBIT (on the right) representing the MAXIMUM
speed setting.
Drive/Lift Mode Selector Switch
Horn Button
Joystick Function Enable Lever
Multifunction Joystick Control
The joystick will operate the following machine functions:
• Drive
• Platform Lift Up and Down
NOTE: Use the Drive/Lift Mode Selector Switch to select
which function the joystick will operate.
The selected operating mode will only remain active
for 5 seconds if the function is not operated.
Remember to press and hold the joystick function
enable lever to operate any joystick functions.
WARNING
WHEN DRIVING WITH PLATFORM LOWERED, DO NOT ATTEMPT
TO DRIVE MACHINE UP A RAMP (GRADE) OF GREATER THAN
FIFTEEN PER CENT (15%).
DRIVING WITH PLATFORM ELEVATED IS RESTRICTED TO A
SMOOTH, FIRM AND LEVEL SURFACE WITHIN 1.5 DEGREES OF
LEVEL IN ANY DIRECTION.
Drive/Lift Mode
Selector Switch
1. LIFT Mode
2. DRIVE Mode
PUSH the rocker
switch to select mode
of operation.
Whichever mode is
selected the appropri-
ate LED indicator on
the display panel
below will light up
showing which mode
has been activated for
joystick operation.
IMPORTANT:
The selected mode
will only remain
active for 5 sec-
onds if the function
is not operated.
1 2
When the machine is
powered on, pressing
this button will sound
the Horn.
Joystick Function
Enable Lever
The Function Enable lever on
the front of the joystick con-
trol, must be engaged and
held in during any joystick
operation.