JLG DVSP Series Operator Manual - Manual (Page 22)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-2 – JLG Lift – 3121135
3.1 GENERAL
IMPORTANT
TH E M A N U FA C TU R E R H A S N O D I R E C T C O N T R OL OV E R
MACHINE APPLICATION AND OPERATION. THE USER AND
OPERATOR ARE RESPONSIBLE FOR CONFORMING WITH GOOD
SAFETY PRACTICES.
This section provides the necessary information needed
to understand control function and operation.
3.2 MACHINE DESCRIPTION
The JLG DVL and DVSP Model Lifts are electric self-pro-
pelled machines with an aerial work platform mounted to
an elevating aluminum mast mechanism. The personnel
lift’s intended purpose is to provide personnel access to
areas above ground level. The DVSP model lift is intended
for stock picking purposes in retail stores or warehouses.
The primary control station is located in the platform.
From the Platform Control Console the operator can drive
the machine and raise or lower the platform.
The controls of the programmable Ground Control Station
are to be used during machine power-up, machine main-
tenance or in case of emergency should the operator in
the platform be unable to lower the platform.
Vibrations emitted by these machines are not hazardous
to an operator working in the platform.
The continuous A-Weighted sound pressure level at the
work platform is less than 70db (A).
NOTE: Machines built to the UL-EE electrical specification
(option) include additional controls and design fea-
tures. These controls are labeled as (EE Only).
3.3 MACHINE OPERATION
Getting Started
The following control conditions must be met before the
machine can be operated from either the Ground or Plat-
form Controls.
• The batteries contain enough voltage to operate the
machine.
• The Main Power Selector Switch on the Gound Control
Station must be set for either Ground Control Mode or
Platform Control Mode.
• Both Emergency Stop Switches, one on the Ground
Control Station the other on the Platform Control Con-
sole must be in the RESET position.
• If equipped, the On/Off Key Switch on the Platform
Console must be set to the ON position.
3.4 BATTERY CHARGING
DVL and DVSP machines are equipped with an AC volt-
age input/DC voltage output battery charger. The charger
automatically terminates charging when the batteries
reach full capacity.
NOTE: The machine’s platform drive function is disabled
when the battery charger is plugged into an AC
receptacle.
Figure 3-1. Battery Charger Location.
1. Battery Charger
Battery Charger Front Panel
1. 120V/5 Amp Breaker 3. 240V/5 Amp Breaker
2. AC Input Voltage Selector
1
1
2
3