JLG DVSP Series Operator Manual - Manual (Page 37)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-17
Adjusting Maximum Drive Speed Control
NOTE: When the platform is elevated the maximum drive
speed is cut-back to 1/4th the speed when the plat-
form is fully lowered. The Ground Control Module-
LCD screen will display a turtle when in this mode,
see Machine LCD Status Display in this section of
the manual.
Maximum Drive Speed Indicator
Elevating/Lowering the Platform
WARNING
IF THE TILT ALARM HAS BEEN ACTIVATED, THE PLATFORM
WILL NOT ELEVATE. ALSO IF THE TILT ALARM HAS BEEN ACTI-
VATED WHEN THE PLATFORM IS ELEVATED, THE DRIVE FUNC-
T I O N W I L L B E D I S A B L E D U N T I L T H E P L A T F O R M I S
COMPLETELY LOWERED.
NOTE: For DVSP Models equipped with the optional
Obstruction Sensing System, see Section 3.14 for
additional platform operation instructions.
1. Drive the machine to the area where overhead work is
to be performed and position the machine into it’s
approximate work position.
5. If necessary, reposition (drive) lift using platform con-
troller joystick to bring work object within reach.
3.9 PARKING MACHINE
1. Drive machine to a well-protected and well-ventilated
area.
2. Ensure the platform is fully lowered, turn the main
power selector switch to the OFF position (centered).
NOTE: If required, charge batteries in preparation for next
work day.
Indicates current
Maximum Drive
Speed Setting.
Slow to Fast.
1. Each Press of this button will
reduce the Maximum Drive
Speed allowed.
(LESS LEDs Lit.)
2. Each Press of this button will
increase the Maximum Drive
Speed allowed.
(MORE LEDs Lit.)
2. PRESS and RELEASE the
Platform Function Button. The
flashing LED indicates the
function is active and will
remain active 3 to 4 seconds.
3. While the Platform Function is
active. PRESS and HOLD the
Enable Button on top the Joy-
stick
4. Push the Joystick FORWARD
from center TO ELEVATE the
Platform.
TO STOP platform movement
return the joystick back to
center.
Pull the Joystick BACK from
center TO LOWER the Plat-
form.