JLG DVSP Series Operator Manual - Manual (Page 47)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-27
3.17 STOCK-PICKER HANGER ACCESSORY
NOTE: The stock-picker hanger accessory is available only
on the JLG DVSP model and is not authorized for
use with any other JLG lift. This hanger accessory is
intended for use in placing or retrieving stock items
such as bicycles, ladders, etc., on racks or shelves
above ground level. Use for any other purpose is not
authorized by JLG.
The hanger accessory is a pivoting arm mounted to the
DVSP platform rail. The hanger accessory can be
mounted to either side of the platform individually, or two
can be mounted, one on each side of the platform. Each
individual hanger has a maximum load capacity of 100 lb.
(45kg).
The hanger arm can be pivoted out of the way parallel
with the platform side rails when not in use, (the stowed
position). The hanger arm is pinned into position at 90
degrees to the platform side rails when in use, (the carry
position).
Pre-Start Inspection
Prior to use of the hanger accessory, check the following;
• Hanger arm mounting is secure to the platform railing,
no missing or damaged fasteners.
• The hanger arm lock pin is in place and secure.
CAUTION
THE COMBINED WEIGHT OF PERSONNEL, MATERIALS, EQUIP-
MENT PLUS ANY LOAD ON THE HANGER ARM ACCESSORY
MUST NOT EXCEED THE MAXIMUM LOAD CAPACITY OF THE
PLATFORM.
Loading and Transporting an Item using the
Hanger Accessory
Use the following steps as a guide when loading and
transporting an object with the hanger accessory arm.
1. Keep the hanger arm in the stowed position when not
in use.
2. When ready to use, pull the lock pin from the stowed
position hole and swing the hanger arm into the carry
position. Place pin in the carry position hole locking the
hanger arm in place.
3. Load the object onto the hanger arm and use the
hanger arm strap to secure the object during transport.
IMPORTANT
DVSP MACHINE’S EQUIPPED WITH THE OBSTRUCTION SENSING
SYSTEM (OSS) OPTION – OBJECTS PLACED ON THE HANGER
ACCESSORY AND EXTENDING BELOW THE BASE OF THE PLAT-
FORM MAY CAUSE AN OSS DETECTION - SOUNDING THE HORN
AND PREVENTING THE PLATFORM FROM LOWERING. IF NECES-
SARY, REPOSITION THE OBJECT OUT OF THE OSS DETECTION
ZONE.
4. Be aware of clearance above, below, and around the
object when driving and lifting or lowering the platform.
Stock Picker Hanger - Carry Position
1. Mounting Bracket 4. Lock Pin (Carry Position)
2. Hanger Arm (Carry Position) 5. Hanger Arm Strap
3. Capacity Decal (a)
Notes: (a) Maximum load capacity of hanger is 100 lb. (45kg).
Stock Picker Hanger - Stowed Position
1. Hanger Arm (Stowed Position)3. Hanger Arm (Carry Position)
2. Lock Pin (Stowed Position)
1
2
4
3
5
1 2
3