Crushing and collision hazard, 4 towing, lifting, and hauling, Crushing and collision hazard -4 – JLG DVSP Series Operator Manual User Manual

Page 14: Towing, lifting, and hauling -4

Advertising
background image

SECTION 1 - SAFETY PRECAUTIONS

1-4

– JLG Lift –

3121135

Crushing And Collision Hazard

• Personal protection equipment must be worn by all

operating and ground personnel.

• Check work area clearances above, on sides, and bot-

tom of platform while driving and lifting or lowering plat-
form.

• During operation, keep all body parts inside platform

railing.

• Always post a lookout when driving in areas where

vision is obstructed.

• Keep non-operating personnel at least 6 ft. (1.8m) away

from machine during all driving operations.

• Limit travel speed according to conditions of ground

surface, congestion, visibility, slope, location of person-
nel, and other factors causing hazards of collision or
injury to personnel.

• Be aware of stopping distances in all drive speeds.

• Do not drive at high speeds in restricted or close quar-

ters or when driving in reverse.

• Exercise extreme caution at all times to prevent obsta-

cles from striking or interfering with operating controls
and persons in the platform.

• Ensure that operators of other overhead and floor level

machines are aware of the aerial work platform’s pres-
ence. Disconnect power to overhead cranes.

• Warn personnel not to work, stand, or walk under a

raised platform. Position barricades on floor as neces-
sary.

1.4 TOWING, LIFTING, AND HAULING

• Never allow personnel in platform while towing, lifting,

or hauling.

• This machine should not be towed, except in the event

of emergency, malfunction, power failure, or loading/
unloading. Refer to the Emergency Procedures Section
of this manual for emergency towing procedures.

• Ensure platform is fully retracted and completely empty

of tools prior to towing, lifting or hauling.

• Do not assist a stuck or disabled machine by pushing

or pulling except by pulling at the chassis tie-down
bars.

• When lifting machine with a forklift, position forks only at

designated areas of the machine. Lift with a forklift of
adequate capacity.

• Refer to the Machine Operation section of this manual

for lifting information.

Advertising
This manual is related to the following products: