JLG DVSP Series Operator Manual - Manual (Page 34)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-14 – JLG Lift – 3121135
Drive Mode
Lift Mode
WARNING
THE GROUND CONTROL STATION CONTAINS A 1.5 DEGREE
TILT ALARM, IF THE TILT ALARM HAS BEEN ACTIVATED, THE
PLATFORM WILL NOT ELEVATE. ALSO IF THE TILT ALARM HAS
BEEN ACTIVATED WHEN THE PLATFORM IS ELEVATED, THE
DRIVE AND LIFT UP FUNCTIONS WILL BE DISABLED UNTIL THE
PLATFORM IS COMPLETELY LOWERED, THEN DRIVEN OFF THE
TILT CONDITION.
Drive Speed Setting Controls
NOTE: When the platform is elevated the maximum drive
speed is automatically cut-back to 1/4th the speed
when the platform is fully lowered. The Ground Con-
trol Module-LCD screen will display a turtle when in
this mode, See page 3-6 - Ground Control - LCD
Status Display in this section of the manual.
1. Activate the Drive
Mode using the Drive/
Lift Mode Selector
switch.
Within 5 seconds of activa-
tion - ENGAGE and HOLD
the JOYSTICK ENABLE
LEVER then move the joy-
stick in the desired direction
of travel. Drive power is
applied proportionally the
further the joystick is
moved off center.
1. Activate the Lift Mode
using the Drive/Lift
Mode Selector switch.
2. Platform LIFT DOWN
Direction
3. Platform LIFT UP
Direction
Within 5 seconds of activa-
tion - ENGAGE and HOLD the
JOYSTICK ENABLE LEVER
then move the joystick in the
direction of LIFT (3) OR
LOWER (2).
1
2
3
Drive Speed Setting
Selector Switch
1. Selector Switch (on top
of joystick)
Each PRESS on this side of
the switch will DECREASE
maximum drive speed.
(FEWER LEDs Lit up on the
Drive Speed Indicator.)
Each PRESS on this side of
the switch will INCREASE
maximum drive speed.
(MORE LEDs Lit up on the
Drive Speed Indicator.)
1