JLG DVSP Series Operator Manual - Manual (Page 41)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-21
3.12 FALL PROTECTION - LANYARD
ATTACHMENT
CAUTION
JLG INDUSTRIES, INC. RECOMMENDS THE OPERATOR IN THE
PLATFORM WEAR A FULL BODY HARNESS WITH A LANYARD
ATTACHED TO AN AUTHORIZED LANYARD ANCHORAGE POINT.
The main lanyard attach point for all DVL/DVSP machines
is located on the lower left side of the mast platform
header, just behind the operators platform.
CAUTION
AFTER ENTERING THE PLATFORM, BEFORE BEGINNING OPER-
ATION ALWAYS CLOSE THE PLATFORM ENTRY GATE(S).
3.13 QUICK-CHANGE PLATFORM MOUNTING
DVL Model Lifts are equipped with quick-change platform
mounts which allow quick removal and installation of cur-
rently available quick-change platforms.
NOTE: DVSP Models require the installation of the Quick-
Change mount kit to use Quick-Change Platforms.
Platform Removal
1. Remove the platform control console from the platform
and lay aside.
2. Remove both upper and lower mount attach pins
securing the platform support rails to the mast mount-
ing channels.
3. Swing and lift the platform out of the mounts and lay
aside.
Platform Installation
1. Set platform in upper and lower mounts.
2. Install attach pins in upper and lower mounts.
3. Attach platform control console to platform rail.
WARNING
ENSURE ALL PINS AND FASTENERS ARE INSTALLED AND
SECURE PRIOR TO OPERATION.
1. Upper Platform Mount 3. Lower Platform Mount
2. Upper Mount Attach Pins 4. Lower Mount Pins
1
3
2
4