JLG DVSP Series Operator Manual - Manual (Page 43)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121135 – JLG Lift – 3-23
3.15 TRANSPORTING, LIFTING AND
TIE DOWN PROCEDURES
General
All DVL Series and DVSP Model Personnel Lifts may be
transported to a work site using the following methods:
• Driving the machine around on its base wheels if travel
surface area permits.
• Loaded, IN AN UPRIGHT POSITION ONLY onto a
heavy-duty vehicle with the payload capacity capable
of supporting the full weight of the machine (Check
machine gross weights in the Operating Spec Chart at
the beginning of this Section).
• Moved with a fork-lift truck using the fork-lift pockets in
the base frame.
Truck Transport
CAUTION
DO NOT TRANSPORT THE MACHINE IN A HORIZONTAL POSI-
TION DUE TO LEAKAGE OF BATTERY ACID FROM THE BATTER-
IES OR HYDRAULIC FLUID FROM THE HYDRAULIC RESERVOIR.
The machine may be winched onto a tilted roll-back truck
bed (see important note following) which has been rolled
back to ground level. Disengage the brakes and always
winch (pull) from the mast (rear) end of the machine,
using the rear tie-down loop attached to the base frame.
IMPORTANT
DO NOT ATTEMPT TO DRIVE MACHINE ONTO, OFF OF, OR PUSH
MACHINE ONTO A TILTED ROLL-BACK TRUCK BED.
THE DVL AND DVSP MACHINES POWER MODULE COULD SUS-
TAIN SERIOUS DAMAGE WHEN THE UNIT IS PUSHED, OR
TOWED AT SPEEDS GREATER THAN 2 MPH.
WHEN TOWING OR WINCHING, THE MACHINE’S BRAKES MUST
BE DISENGAGED.
RE-ENGAGE THE BRAKES ONCE MACHINE IS IN PLACE WITH
TRUCK BED LEVEL AND READY FOR TIE DOWN.
TIE DOWN LOOPS ARE PROVIDED ON BOTH ENDS OF THE BASE
FRAME TO SECURE MACHINE TO BED OF TRANSPORT VEHICLE.
Figure 3-9. OSS - Pre-Start Inspection of Operation.
1. Electronic Module LED Indicator (a)
2. Detection Zone
3. Place a pad of paper or similar size object, 6 to
12 in. (15 to 30cm) individually beneath each
transducer to check detection.
Notes: (a) The LED Indicator will flash when an object is
detected at each sensor. Remove object and allow
the LED to stop flashing before testing next sensor.
1
2
3