JLG DVSP Series Operator Manual - Manual (Page 46)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-26 – JLG Lift – 3121135
Removing a Rug using Rug Carrier Accessory
Arms
This section describes the use of the Rug Carrier acces-
sory in removing a rug from a horizontal pivoting arm dis-
play rack.
1. Select the intended location in the display for removal
of the rug. Open the display rack to provide adequate
space for the DVSP lift and rug.
2. With the Rug Carrier Accessory arms stowed, drive the
DVSP into position prior to loading the rug.
3. Swing and lock the Rug Carrier Accessory arms into
the carry position.
4. Elevate the platform a few feet. Start to roll the rug onto
the Rug Carrier Accessory arms.
5. Be certain the rug is centered over its length on the
Rug Carrier Accessory.
6. While elevating to the required height for removing the
rug from the display arm, continue to roll the rug until it
is completely rolled up on the carrier arms.
7. Properly remove the rug from the display arm. Never
climb onto the platform rails for any reason.
8. After adequately removing the rug from the display
arm, lower the platform.
9. Remove the rug from the Rug Carrier Accessory. If
required, use an assistant to unload the rug from the
Rug Carrier Accessory Arms.
10. Replace the Rug Hanger Accessory arms to the
stowed position for normal operation.
CAUTION
THE RUG CARRIER ACCESSORY ARMS MUST BE LOCKED IN
THE STOWED POSITION WHEN NOT IN USE.
EXTREME CAUTION MUST BE EXERCISED AT ALL TIMES WHILE
THE RUG CARRIER ACCESSORY IS IN USE (DRIVING, RAISING
AND LOWERING) TO PREVENT OBSTACLES AND PERSONNEL
FROM STRIKING THE LOAD.
WHEN DRIVING WITH A RUG WITHIN THE RUG CARRIER ACCES-
SORY, THE RUG MUST BE PROPERLY SECURED TO PREVENT
INADVERTENT MOTION OR MOVEMENT OF THE RUG AND MUST
NOT EXCEED THE RATED CAPACITY OF THE RUG CARRIER
ACCESSORY.
NEVER OVERLOAD THE RUG CARRIER ACCESSORY. MAXIMUM
CAPACITY OF THE RUG CARRIER ACCESSORY IS 150 LBS.
THE COMBINED WEIGHT OF PERSONNEL, MATERIALS, EQUIP-
MENT PLUS ANY LOAD ON THE RUG CARRIER ACCESSORY
MUST NOT EXCEED THE MAXIMUM CAPACITY OF THE PLAT-
FORM.
NEVER USE A RUG CARRIER ACCESSORY THAT HAS DAMAGE
OR LOOSE MOUNTINGS. IMMEDIATELY REPORT ANY DAMAGE
TO APPROPRIATE PERSONNEL. DISCONTINUE USE OF THE
RUG CARRIER ACCESSORY UNTIL ALL DISCREPANCIES HAVE
BEEN CORRECTED.
Removing Rug From Display Arm.
1. Roll Rug onto Rug Carrier while Elevating Platform
2. Rug Carrier in Carry Position
1
2